Books › The Repairing & Restoration of Violins, 1903 › scan 80
Scan 80
The Repairing & Restoration of Violins, 1903
6 lines. Read by computer on 3 September 2026. Printed page 66. See the scan on archive.org.
1The wood to be cleared away outside the lines which mark the width along the course of the fingerboard will be the next proceeding; it may be done neatly with a rather fine toothed saw and then carefully planed up closer to the lines, barely touching them. It is preferable to leave the sides for the present at right angles with the top surface, although they will not be kept so for long, but by thus working the measurements are facilitated. Going to the lower or wider end a line must be accurately marked quite square with the long central line, if not accurate the whole work will be thrown out of truth. On the sides there may now be marked and roughly sawn away (diagram 28) so much of the wood that shall leave
3
5enough for the cylindrical part that is to be finally rounded and finished off for handling. Care must be taken that the rounding commences underneath, a little away from the part that will be fitted into the peg-box. This of course must be according to measurement or template kept for the purpose if graftings are likely to be wanted in the future. There will now be required the marking of the exact form of the part that is to be inserted in the body of the violin, or more strictly speaking, into the upper block. This is done easily from a pattern cut to shape and size for instruments of average proportions. Sometimes, owing to the height of the ribs, the pattern cannot be applied so as to fit; in that case fresh lines
The computer misreads some letters and numbers. Where a name matters to you, read the scan.