Books › The Repairing & Restoration of Violins, 1903 › scan 86
Scan 86
The Repairing & Restoration of Violins, 1903
8 lines. Read by computer on 3 September 2026. Printed page 68. See the scan on archive.org.
1keen edged chisel and small shavings cut at a stroke, as there will be some cutting against the grain to be done besides working in a confined position.
3Great regard must be paid during the process of cutting this part that the corners or angles are quite cleared out, or the neck when inserted as a trial or rehearsal will not give a truthful report of the accuracy of the incisions owing to some insignificant portions sticking up and causing the neck to look awry. So far we may take the fitting as having been accurately done to the central line down the middle of the instrument; but now comes a further process in connection with the adjustment of the neck, and that is, the rise and inclination of the level of the fingerboard in relation to the bridge which is to be fitted eventually.
5The average—it may almost be called the standard—height of the violin bridge is one three-eighth inches. There are occasions when this measurement may be departed from, as in the instance of a high model, when an eighth, or even more, may be taken off with advantage. This must not be taken as necessary for the proper emission of the tone from a highly built instrument. The raising of the bridge in modern times is due to other causes, the most important being that of allowing better play or room for bowing rapidly over from side to side without rasping the border at the waist. It is an alteration which accompanied the lengthening of the neck and stop in the early part of the last century.
7To obtain a proper setting or inclination of the neck, several ways are adopted by repairers. They vary according to the kind of guide or pattern used. This is usually cut from a piece of hard wood, sycamore or pear. It is sometimes made as a double guide in the adjustment of both the inclination and the elevation of the under part of the fingerboard above the body of the instrument at the junction of the neck. This we will call No. 1. The other, No. 2, is similar but has the height of the bridge only as a fixture, the rise of the end of the neck above the border being higher and lower at discretion. Another
The computer misreads some letters and numbers. Where a name matters to you, read the scan.