Books › Violin making, 1902 › scan 53
Scan 53
Violin making, 1902
6 lines. Read by computer on 3 September 2026. Printed page 25. See the scan on archive.org.
1the main body of the still rougher oblong wood, and it must now be my business to cut this rough outline to its true form, which is done by looking at the flat side where this pencil outline is, and with a very sharp, flat-ground knife, specially made for violin makers, tool 19. But before this is done, the main body must be reduced at the edges, on the convex or outer side, of course, to about the thickness of three-sixteenths of an inch good, which is a simple matter, if done with one and a quarter inch gouge 43, in this manner.
3In the middle of the bench, which will be your general one, and five inches from the edge, cut a one-inch square right through the wood, and fit a long stop therein, the tighter the better, and somewhat rounded off at the inner corner facing you. This will serve to keep one end of back or belly rigid when the other end is provided for, as I do thus:—About fifteen inches from this square top, and to your right, clamp down a piece of hard wood, three inches broad, and a quarter of an inch thick, square with the bench, and on both sides. Then cut a square hole in it, five inches from bench side, to enable you to allow the rough button to lie whilst you operate on one side of the back, then on the other. This, as you must see, enables the wood upon which you are to work, perfect freedom from obstruction of any sort, whilst the gouge cuts roughly all round, as shown in plate 3.
5So, leaving the convex side as it is for the present, I resume, as to cutting to the true outline with the knife. You can begin where you like, but I generally clear the
The computer misreads some letters and numbers. Where a name matters to you, read the scan.